45045 Exposure Head Interface EHI: unable to find exposure power, set to 0 W Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 During stroke cal in laser modes 1 and 2, the head will attempt to update the hdm NVS parameter "wpowere". However, the update will be unsuccessful if the head NVS parameters "hsslope" and "hsoffset" are not set properly. In addition, the update could timeout without finding the appropriate "wpowere" value. This error code applies to Thermal Head firmware version 1.56 and above. Try imaging again. If problem persists, call service. This error is reported. Unsuccessful "wpowere" update during stroke cal in laser modes 1 or 2. 03-Jul-2002 ../prm/ehi_hdm_wpowere.xmlPRM: hdm wpowere ../prm/ehi_head_hsslope.xmlPRM: head hsslope ../prm/ehi_head_hsoffset.xmlPRM: head hsoffset ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:44 2008 PST